5.5 Bullet parallel conectors

[MarkF]

Thats a very good Idea. The only thing I would change is to use copper tubbing instead of the brass since it conducts electricity a little better.

Mark

[FloatDaBoat]

Thats a very good Idea. The only thing I would change is to use copper tubbing instead of the brass since it conducts electricity a little better.

Mark

A WHOLE LOT better !!!

[egneg]

Thats a very good Idea. The only thing I would change is to use copper tubbing instead of the brass since it conducts electricity a little better.

Mark

No need to over-engineer this as the brass works just fine without any heat due to resistance.

[properchopper]

DSC02320.JPGDSC02321.JPGChuck, a big thanks for this idea

Some 8's I made for a customer :

[egneg]

[ATTACH=CONFIG]54685[/ATTACH][ATTACH=CONFIG]54686[/ATTACH]Chuck, a big thanks for this idea

Some 8's I made for a customer :

Actually Steven V did it first, all I did was add pictures in a step by step format. Before this I used 8 awg stranded wire but this is much easier.

[Joe007]

Thanks for all the help here on making the double connection out of the bullet connectors... I went on line and on ebay found Tough Racing out of Seoul Korea, they have the 5.5 bullets with holes though both ends.... I got ten pairs with shrink wrap tubing for like $8.00 shipped to my house... Took less than two weeks to get them...

[Basstronics]

Heres a new twist...

HobbyKing 8mm bullets. .155 solid brass rod- right thru the stock holes!

I made mine to fit the batteries. So I have 2 males/1 female, 2 females/1 male

[Serpents811]

i made a set with cc 6.5 bullets but still havent found heat shrink big enough , help here with that

[ron1950]

if your heat shrink is close to the size but not quit the right size streatch it with a pair of needle nose plyers...heat will bring it back to size