Someone double check my order

[aquinosteven]

So i just picked up a used mini v. Im looking to keep it cheap (under $100) I would like to stay brushed maybe a 480 but i still gotta find a reasonable ESC. Im not running Lipo. Anyway Im keeping the outdrive but i just want to change the prop shaft.

Prop shaft
http://www.offshoreelectrics.com/pro...od=oct-ocgcss4

5/32" brass for Octura .098 Flex Cable.
http://www.offshoreelectrics.com/pro...rass-tb&cat=70

Now i just need a prop. Any suggestions. (Please link)

[Diegoboy]

Octura X430 Sharpened & Balanced

Or

Octura X430 Raw

[aquinosteven]

you think i could get away with the unsharpened one? and is the prop shaft right?

[Diegoboy]

No. It will need to be balanced.

I used a 1/8 prop shaft (the one you list is a 4mm - slightly bigger in the strut or outdrive then reduced to 1/8 for the prop)
The one I used was This.

[aquinosteven]

So there im just using the shaft. Do i have to convert to the flex cable when using that shaft?

[Diegoboy]

Ahh. Ok. Use the one you selected, you may have to enlarge the outdrive bore to accept it.

[aquinosteven]

yeah, I was planning to drill out anyway to accept the 5/32" copper tube

[Diegoboy]

You're good then!!

[aquinosteven]

Thanks a ton!

[befu]

I run a 430 or 431 on mine stock, plastic.

I use an octura 1/18" prop shaft and replace the u joints with .093 flex cable, but keep the 3mm solid drive shaft. Cheap conversion that way, I had to do 6 of them!

Brian

[aquinosteven]

Ordered up the prop and the shaft along with a new u joint. Mine was all rusted. had to drill it out to get the old prop shaft out. Looks like its staying this way for now but i wanna run the mini car hardware in the future. I found it on there website, i just gotta pair it all up.