Strut height

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • srislash
    Not there yet
    • Mar 2011
    • 7673

    #1

    Strut height

    Hey guys,I am putting together a PB Miss Bud (same as Elam)and am going to set a new stuffing tube with a exterior strut.What I need to know is roughly the height of the strut so I can epoxy my tube in.Thanks in advance, Shawn

    So to add;this is a partially converted hull that I got.Here is what I have so far

    The motor is a Hacker B50 6XL 2630kv



    It came with the rudder and I got this strut for it



    And it had a broken tube in it and the old setup was removed



    So if you guys can help me set my strut height so that I don't end up putting too much pressure on it later with adjustments it would be appreciated.Thanks again
    Last edited by srislash; 07-05-2012, 11:56 AM.
  • monojeff
    Moderator
    • Nov 2010
    • 2561

    #2
    Did you ever get the strut figured out if not let me know and I can tell you what mine is set at.
    OSE GIFTING ELF
    HAPPY HOLIDAYS!!

    Comment

    • srislash
      Not there yet
      • Mar 2011
      • 7673

      #3
      I got it running fairly well.Changed to a 1512 2650 motor,set the strut centerline at 5/8 from the bottom where the strut is not the rear pads.This isn't a very good vid to see how it runs but http://www.youtube.com/watch?v=guG4R...&feature=g-upl

      Comment

      Working...