"that" miss geico

[srislash]

Not all of them.It must be the quality of the flex.Oddly enough,my most expensive flex's to date.The ones I got from Randy (BBY) are awesome.Removeing them is just habit now and greasing them is my morning ritual.Along with COFFEE.

[masonis1]

Ok cool. Hah i.need a thicker grezse cuzbthis stuff now is just a little thicker than wd40 and it flings out around the collet. I have an oil.stain all the way around the hull on the inside. Hah

Sent from my SPH-D700 using Tapatalk 2

[srislash]

I picked up some Lucas marine Blue grease and it works awesome.I'm good for 4-5 runs and the shaft still has some on it when I pull it out.

[masonis1]

This stuff is from ofe and seems good

Sent from my SPH-D700 using Tapatalk 2

[masonis1]

So looking for a esc now. Starting to miss my crawler too so I need to get a small lip for that and I'm also missing my brushless rc10.need to make a 5.5 mm bullet adapter to think 4 or 4.5 so I can use my ezrun 150a esc on my rc10. Busy but its summer now...

Sent from my SPH-D700 using Tapatalk 2

[masonis1]

So now my big truggy is gutted of everything except the motor. Almost roller. I'm wondering if that.motor can fit in the mg and if the t180 can take it?

Sent from my SPH-D700 using Tapatalk 2

[srislash]

Is that the Tork?If so,no problem,With a X645

[masonis1]

No it is a castle mamba monster 2200 kv

Sent from my SPH-D700 using Tapatalk 2

[srislash]

So it is a 1515 like mine,same as mine.That'll push a 645.I'm going to try more this weekend.I'm going to lake country.

If you end up wanting it to live in the MG I could make a mount for you.But to try it the stock mount will work.But soon very soon you will need to support the motor better.
Jason's 004.jpg180 002.jpg

[masonis1]

So id need to get a mount for it. What about cooling with the fins

Sent from my SPH-D700 using Tapatalk 2

[srislash]

OSE sells the cooling can.

[masonis1]

Are these 5.5?
Here is the cc1515


Sent from my SPH-D700 using Tapatalk 2

[srislash]

That is factory Castle ? Then they are 6.5's. And here is the cooling can.http://www.offshoreelectrics.com/pro...ham-castle1515

I got to go to work.

[masonis1]

No those are from the ezrun esc. How can I measure them first?

Sent from my SPH-D700 using Tapatalk 2

[masonis1]

They measure 6mm on the esc. And the motor plugs are the same. Is that 5.5?

Sent from my SPH-D700 using Tapatalk 2