anyone know the width of the Kintec offset rudder bracket for the Miss geico.

[martin]

Hi does anyone have any dimensions for the Kintec off set rudder bracket ie length off both angle faces, Thank you .

[tlandauer]

I will try my best to post here as i am not good at drawing, all dimensions are in metrics (sorry, now you know I am a foreigner)and are approx.Kintec Offset RudderBracket for MG 001.jpg
Well, just noticed that you are from UK, never mind, when I came to the US 30 years ago, we were trying to go metric, but that never materialized.

[martin]

Hi thats just what i was looking for, would you have the spacing on the tapped holes & how far in from the ends they are as well. Yes in the UK its a mixed bag regarding imperial & metric but mainly metric. Thank you.

[tlandauer]

The space between the two tapped holes ( where it mates to the original bracket) is 15 mm, the machine screws they include are M3x15, bottom hole goes thru, top one --I can't tell how deep it runs into the aluminum, sorry, mine is installed with thread locker. When you put everything together, the M3 goes into the Kintec approx. 6mm. I remember the top M3 goes in further than that before I installed it, but exactly how much I don't know. Hope this helps a bit.
Tim

[martin]

So does that make the centre to centre of the holes 18mm. I take it its 15mm to the inner edges of both holes.

[tlandauer]

Centre to centre! not inner edges.