Tweet
I deceided to relocate the hardware in my boat, batteries and esc. After that when I went to try the boat I was getting alot of servo twitching to the point where I couldn't really operate the boat. Can anyone tell me how I can fix this or what the problem is?
-
-
What rx/tx are you running?
Brushless systems cause alot of interferance with the Am/Fm radio signal if the motor/esc is to close to the reciver antenna.
DanielWhen you know it all.......you never will learn anything new
-
I'm using the standard one that comes with the boat.Comment
-
What brand boat? Does the radio have a extendable antenna?When you know it all.......you never will learn anything newComment
-
Oh my bad, its the mss geico. I not sure why but there are 2 antenna wires comming from the receiver.Comment
-
short one stays in the boat ...long wire goes into the antenna tubeMY RETIREMENT PLAN?????.....POWERBALL
74 vintage kirby clasic hydro, pursuit mono, mg, 47'' mono, popeye hydro...
Comment
Comment