Programming for lipos on MG

[Diesel6401]

What settings would you use on the seaking 180amp esc for my CC/Neu 1512, 1800kv motor?

I have that motor. I plan on running it a default 15.00 to start. Not sure if it's right or not. I run my leopards at that timing and they like it.

[blackcat26]

15deg works good on mine on 6s. Neu recommends a little higher timing like 15 on the "y" winds.

[POWERS]

Just want to make sure the programming worked.

I plugged the programmer in turned the on switch on and it beeped once, I turn the power off, disconnect the programmer, and reconnect the receiver. When i turn the power back on the only thing that works is the steering, pull the throttle and nothing. SO i turn it off and unplug a battery and plug it back in then everything works. Is this normal?

[ron1950]

yes u have to disconect the batteries before it takes for some reason....i think its supposed to beep twice now when u turn it on if linerer throttle was selected

[FrostyNutz]

yes u have to disconect the batteries before it takes for some reason....i think its supposed to beep twice now when u turn it on if linerer throttle was selected

Thanks Ron ,, I just scratching my head wondering why my motor wouldn't run . This site rocks