Brushless programable card

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Chewy6696
    Junior Member
    • Apr 2009
    • 14
    #1

    Brushless programable card

    Just wondering what I am may be doing wrong......

    I plugged in the program card and followed instructions... when I powered on the on/off switch i did not get any beeps.. when I hooked it back up the steering worked but I had NO THROTLE !!

    Any ideas what might be going on. I did the reset of turning on boat with full throttle and then it would work again.....

    I am confused !!!
    Tags: None
    • TCR
      Senior Member
      • May 2009
      • 139
      #2
      You put freash bats to the esc and plugged it(esc only into the right side of the program card, turned the sw to on on the esc and no beep?
      Tom

        Comment

        • Chewy6696
          Junior Member
          • Apr 2009
          • 14
          #3
          Batts were fresh from the charger. Plugged to the right side and turned on the power...... No beeping. I did get to beep when I changed up the settings.. but I still had no throttle when I squeezed trigger. Steering was working when I would turn the wheel.

            Comment

            Previous template Next
            Working...