Tweet
I am thinking about the cat hardware what do I need exactly what also the the collet nut goes to the flex drive and then what does that connect to in the fullers also I have a grimmracer prop
-
-
When i purchased the Fuller's Cat Hardware, All i had to do was drill 2 holes, you can use the original top holes where the outdrive mounts.
My hardware came with a flex shaft with propshaft and drivedog already preinstalled. All you should have to do is cut down the flex cable to the appropriate length.
My flex shaft fit into the stock coupler on the motor, i recommend adding a bit of solder to the end of the flex shaft after cutting it to the appropriate length. Remember to leave a slight gap about 1/8'' between the drive dog and strut.This flex shaft even came with a prop nut.
You will need some servo pushrod and a linkage to adapt to the horn on the rudder and you.
hope i helped
--Chris -
where did you get it how muchComment
-
This is the fullers website
They also have an ebay store, here is the hardware your looking for.
EDIT:Be sure to note when you order that if you want a 3/16ths shaft to tell the guys at fullers you would like a .150 flex cableComment
-
thanks so much last thing how did you make the steering workComment
Comment