whats the weight of your BJ26 ??

[MAXAMUS]

Hi all

just been giving my BJ26 an overhaul and a spring clean have tightened up the battery security after a double barrel roll on Sunday where a battery came loose and was rattling about also a better means for holding in my garmin 101 GPS lubed tightened and cleaned up the hardware and decided i was going to weigh my BJ26 at a pond ready state and it came in bang on 5lb

and that's what prompted me to start this thread what is a good weight or reasonable weight pond ready for a BJ26 ?

5LB ready to go and here's my set up

fullers hardware
ammo 2300
ETTI 150 amp
2x 20c 6600 mah lipo
octura x642 (b,s)
futaba fasst 2.4 GHz Rx
1500 mah Rx bat pack
garmin 101 GPS
PB stock servo
battery trays and the tupperware box removed

Maxamus.........

[NativePaul]

I don't have one but my Crestrunner 36" cat

was 5.6lb with it's 6s 4350mah (similar battery weight) setup, so it is not too bad.

[MAXAMUS]

Nice boat man

Ive been unable to unleash the power yet due to the wind whipping up and being a bit rough at the pond so i adjusted to run a little wet but she sits well in the water and with only 1/2 throtle managed a 38.3 mph on the GPS so will wait for better conditions and poss will get some 3 cell