Head of the River hardware question

[Duclover]

Yes, yet another question in regards to hardware as I'm a shopping fool. I've found a setup on the infamous Ebay (link below) and am wondering if anyone has an opinion on it. Works out to about 2/3 of the Fuller's gear as far as pricebut rather than the 3/16 Fuller's version this one has a 4mm flex cable and a rudder thats a bit deeper. Would this setup be too big for the BJ 26?

http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&ssPageName=STRK:MEWAX:IT&item=290275208771

As always thanks for any input- Duc

[dodge4x4]

not sure about the 4mm size flex cable. size looks ok though. I don't know anyone that has tried this yet. you can look at my post
at 3 excellent hardware upgrades a few posts down. these work for sure

[frdvschvy]

Yes, yet another question in regards to hardware as I'm a shopping fool. I've found a setup on the infamous Ebay (link below) and am wondering if anyone has an opinion on it. Works out to about 2/3 of the Fuller's gear as far as pricebut rather than the 3/16 Fuller's version this one has a 4mm flex cable and a rudder thats a bit deeper. Would this setup be too big for the BJ 26?

http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&ssPageName=STRK:MEWAX:IT&item=290275208771

As always thanks for any input- Duc

Looks like this would put the strut awefully close to the transom. You might want to look at some other options that would allow you to run a larger prop shaft and flex cable. I just did a Speedmaster strut, new .150 flex cable w/ 3/16 prop shaft and Proboat Formula Fastech rudder for about the same cost as this ebay piece.