Octura propeller

[Tony]

I have an octura x642 prop on my bj26 . What other octura prop are you guys using? Are there any different?

[Apples1]

i also use a 645 and a 940 3 blade. with mixed results some good some bad!

[obrien]

Have you done any modifications to your 642? I am running one that is detongued and pretty sharp

[Tony]

I got mine here on OSE , sharpened and balanced. I want to get another one , but they are out of stock.

[ETOWNE]

I'm running a m445 b/s/p . I have 2 2s Team Checkpoint 5400's, stock motor and esc, and fullers offset hardware. The boat turns now and I ran 43 mph on Gps. I had a x642 and it seemed to torquey.

[Tony]

I'm running a m445 b/s/p . I have 2 2s Team Checkpoint 5400's, stock motor and esc, and fullers offset hardware. The boat turns now and I ran 43 mph on Gps. I had a x642 and it seemed to torquey.

Where did you get your m445 prop and TC batt? Was your x642 balance and sharpen?

[Jeepers]

This tip comes from one of the fastest guys on the water(and its not me) This is what I was told.

"DONT OVER PROP A BRUSHLESS MOTOR".

[Wakesurfer]

I'm running a M455 balanced and speed beaded on a TLR Skater II on mine. Don't have a GPS for it, but it looks quicker than stock. I angled the T fins and took a 1/2" off at the same time I switched drives and props. Lowered and moved the batts back to, so it's hard to say what helped what. All I know is I like it better than the stock setup. What prop would you recomend for the stock motor and ESC on 6s, and for a Hydra 120/F 7xl on 6s LiPo?

[ETOWNE]

Tony, I got my lipo's from my LHS, here's the web page.http://www.russellrc.com/index.php?m...ex&cPath=48_63
My prop came from ICE329 from here on the forum.