Help with Lipo Programmer

[jayfive]

Help with using losi esc programmer can I?

My local hobby shop told me to program the esc with a losi quick programming card. will my esc be ok with these settings?

Running 2s 4000mah packs
cutoff for 2s
brake for low
drag brake low
vehicle speed max
reverse speed max
motor timing more speed

Thanks in advance for any help
going to try this today and will post results of cutoff voltage after my run

btw the losi programmer is half the price of the pro boat

[jayfive]

Losi ESC programmer

I ran the boat three times with three sets of batteries yesterday with 18min to 22min runs on the first charge with the following setup:

Running lipo 7.4v 2s 4000mah packs

ESC settings were as follows:

cutoff for = 2s
brake for = low
drag brake = low
vehicle speed = max
reverse speed = max
motor timing = more speed

I was more than pleased with the performance of boat right out of the box and am no longer worried about programming, bringing the boat in immediately after esc cut out the lipos tested between 7.2v to 6.0v. I will warn there was not much time return the boat after cut out so plan accordingly.

planning to race a blackjack 55 gas boat in the upcoming weeks I will report any details.

BTW can anyone report on how useful trim tabs or a "dolphin" would be?