Tweet
you thihnk you can add in that little tab in the front?
-
snort pixi sticks=symptoms-:
-
Honestly no/. Its just as safe to tape the hatch. With the lip on the hatch it fits pretty snug and doesnt move much even without tape. It was just too much to do the tabs. I did try and just didnt seem worth the trouble. Im no pro hull maker for sure I was just curious if I could do it. I dont have fancy vacuum table or anything but they come out pretty rigid and smooth.Comment
-
ohh that no problem. jhust wondering if you tryed it
when i get paid at the end of trhe week i will have one in my hands!!
snort pixi sticks=symptoms-: Comment
-
MM, is the hatch all ready for paint or do I have to sand and fill the hatch... The photo's of the hatch are not prepped can see the glass fibers...
I really like the lid..
Joe007Comment
-
When I do them I release them from the mold, clean it, then put it back on mold and do some sanding. You can see the fibres but it is inside clear resin. Once it gets sanded its ready for prime and paint. I usually dont even mess with the inside cept for cleaning the release wax.Comment
-
Ok sounds good to me...
Also what is the weight difference between yours and the stock lid..
Joe007Comment
-
Did this hatch ever become available???IMPBA: 7-Time FE World Record Holder "Don't think outside the box. Rather, refuse to admit that the box exists in the first place!"
MGM Controllers - Giant Power Lipos - ML Boatworks - Wholt's Wire Drives & Struts - Nano-Oil
Comment
-
How did you make these molds?
B/c the surface finish on the molds doesn't look like it will allow you to paint in the mold and get a nice shiny surface.
You might want to try polishing your mold.
Shoot for a finish like this:
Comment
-
Sorry, double post...Comment
Comment