New speedmaster hardware

[G-UNIT]

Here are some shots of my new hardware (speedmaster).
I think I need to shorten the stuffing tube a bit so i can change the prop angle,
what do you guys thinK, all comments welcome.


http://forums.offshoreelectrics.com/...pictureid=1601

http://forums.offshoreelectrics.com/...pictureid=1602

http://forums.offshoreelectrics.com/...pictureid=1599
http://forums.offshoreelectrics.com/...pictureid=1603

http://forums.offshoreelectrics.com/...pictureid=1600

[Doby]

Try again......

[wakeboardfusion]

looks good!

[Steven Vaccaro]

g-unit which bearing are you using in the strut?

[G-UNIT]

Its a octora prop bearing p/n octoc6tb 3/16 shaft price 12.95.
and its in the proper place,
theres another thread showing a bearing between the motor and flex shaft coupler and i just don't see any thrust in that position.
if you don't use a bearing where mine is at least leave a space the thickness of the flex shaft between the dog and strut.

[Steven Vaccaro]

G-Unit I mean the bearing inside the strut. Is it the long brass speedmaster bushing?

[G-UNIT]

Ok. sorry the bushing I used in the strut are a prop reducer bushings, they are about 1" long
and I put one in each end of the strut, I could'ent find the one your showing but what i did is working fine so far. the bushing size on the package is .250/.187 and the prop shaft fits it just fine.