Servo reversing

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • xbrute
    Junior Member
    • Nov 2009
    • 1

    #1

    Servo reversing

    Hey guys new to boats been into gas and electric helis for a couple of years. Enjoy my BJ26 and i am about to go lipo and hardware route! Just you opinion on hardware, i am thinking of running the BJ nitro hardware and it looks like it will be a good choice but in order to run the offset rudder i need to reverse the servo. Where on the stock RTR transmitter is the servo reversing switch? Have read most of the forum and i am enjoying it, and finding it hard not to buy a big gas boat with the 26cc engine. Anyway thanks for your advise and thank you for the forum!
    Last edited by xbrute; 12-08-2009, 02:34 AM. Reason: spelling
  • LiPo Power
    DJI Drone Advanced Pilot
    • May 2009
    • 3186

    #2
    Originally posted by xbrute
    Hey guys new to boats been into gas and electric helis for a couple of years. Enjoy my BJ26 and i am about to go lipo and hardware route! Just you opinion on hardware, i am thinking of running the BJ nitro hardware and it looks like it will be a good choice but in order to run the offset rudder i need to reverse the servo. Where on the stock RTR transmitter is the servo reversing switch? Have read most of the forum and i am enjoying it, and finding it hard not to buy a big gas boat with the 26cc engine. Anyway thanks for your advise and thank you for the forum!
    There is two switches on the top edge of your transmitter....
    DJI Drone Advanced Pilot
    Canada

    Comment

    • jamespl
      Senior Member
      • Oct 2009
      • 742

      #3
      I'm currently outfitting mine with the nitro harware. All I did was order the nitro rudder pushrod arm, done away with the Tupperware dish and move the servo further back. I will post some pics when I get chance
      http://inlinethumb55.webshots.com/32...600x600Q85.jpg
      http://inlinethumb04.webshots.com/45...600x600Q85.jpg

      Comment

      • wakeboardfusion
        Senior Member
        • Oct 2008
        • 462

        #4
        let us know how it handles when you try it

        Comment

        Working...