Really having a blast with my UL-1

[Wade]

What a blast. Plug it in and go. Simple and a blast to run. I have been working on prop selection and placment to figure out what works best for the UL-1 and how I want to see it run. So far temps have been in check with high 90's on the motor, 115's for the ESC and Batterys hovering around 125/127. Have not put my Garmin in this one yet but i feel it is getting into the high 30's/low 40's and it can take wide turns at full speed with no issue. Real fun boat.

[Heaving Earth]

they really are fun! the best prop for this sucker is l40/57/3 imo. getcha 50mph if setup rite on stock power

[Wade]

they really are fun! the best prop for this sucker is l40/57/3 imo. getcha 50mph if setup rite on stock power

Thanks for the heads up on the 40 57 3. Do not have that one...will pick on up and give it a go

[rc2266]

Was running a M445 on mine, ran 54 on gps all day long, also easier to s/b

[Heaving Earth]

Wade, you must sharpen and balance this prop well otherwise it's a bitch to make it work.
Rc2266, I also tried the m445. It was really fast but completely out of control. The boat was all over the place.
Personally I prefer 50 and stable over 55 and wacky

[rc2266]

Was crazy too til I put batts in sponson, then drove on railsBatt mod.jpg

[MR2NR]

Did you have to cut out the hull for the Batts? New to the UL1 scene.

[Jersey Crewmax]

Was crazy too til I put batts in sponson, then drove on rails[ATTACH=CONFIG]80721[/ATTACH]

Did you seal the holes you made for the batteries?

[rc2266]

MR2, yes I cut holes to put batts in, Jersey, no I did not seal the holes, I tape the top good soo never an issue.

[stelerzman]

How reliable was this mod?