ul1 is rippin it!!! whats next?

[steveo]

rodbe where are you in fla.

[rc2266]

All I know is that since I hit 50 it's been almost uncontrolable.

[Rob DeAngelis]

Im in miami close to metro zoo....

[quadracer196]

Sanding the hull for better performance of my UL-1

I was just curious if any one has tried any other methods of breaking the surface tension of the water like a clearcoat with really fine grit in it. Or would the surface of the grit actually defeat the purpose and cause an increase in surface tension just trying to think of an idea that doesnt involve sanding on a boat that i just bought i might do more damage than good. Any insight into this would be greatly appreciated.

[Rumdog]

You're only lightly sanding the running srface. On a hydro, just the ride pads of the sponsons. Very high grit paper. You wont hurt a thing.

[Fluxn81]

A few of us have had great success with the Spartan. I love mine.

[DBQuick]

A motley Crew is my next project after my UL-1 which I just love.

[Rob DeAngelis]

the MC is a sweet looking boat... Got mine today and man it looks pretty....

[Grimracer]

remember.. the UL-1 has gone over 60 on 4S.. again not for the newbie but it can be done.. pay your dues and it can be done!

ROCK AND ROLL UL-1!

Grim

[quadracer196]

remember.. the UL-1 has gone over 60 on 4S.. again not for the newbie but it can be done.. pay your dues and it can be done!

ROCK AND ROLL UL-1!
What is the total amount of dues to reach the 60 mph mark was the hull reinforced with cf or heavier glass i would like to try this eventually Ican always pick up a replacement hull on the ose site if things turn ugly. IS there a video of this run?
Grim

What is the total amount of dues to reach the 60 mph mark was the hull reinforced with cf or heavier glass,I would like to attempt this eventually. Ican always pick up a replacement hull. Is there any vide of this run or info on the esc motor setup?

[quadracer196]

i think my prop choice is pushing me in the right direction put a Prather B-230 is this a step in the right direction or am i hurting my electronics motor is 120 degrees after a nice long run trying to get the 60 mph point

[rc2266]

I run mine all stock except m445 prop and I have my batteries in sideways, just had to do alittle cutting, got 58.6 on gps other day