MC Build, Castle 2400kv set-up and suggestions.

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • 704Authentic
    Senior Member
    • Nov 2012
    • 178

    #1

    MC Build, Castle 2400kv set-up and suggestions.

    I'm about to install the following in a MC: (as soon as soldering tips arrive)

    Castle 1415 2400kv
    Seaking 180
    (2) 4500mah 2s 50-100c
    All on 6.5 bullets
    42x55 prop (starting point)
    (will eventually foam and carbon interior later, if needed)

    I'm sure this has been done before, someone on here...
    What top speed can I expect? Best Prop? Temps?
    Is this a good set-up? Looks good to me, but.
    Looking for suggestions and trying to minimize future situations.

    All information is appreciated. Thanks,
    AquaCraft UL-1 59mph.
    Motley Crew 61mph.
    JAE 21FE ~~~ 70 MPH Club ~~~
  • Heaving Earth
    Banned
    • Jun 2012
    • 1877

    #2
    Speeds Will be Uhm..... Much faster than stock. Somewhere in the mid to high 50's I think.
    Did you grab a 1/8 motor collet for it? Stock one ain't gonna work

    Comment

    • 704Authentic
      Senior Member
      • Nov 2012
      • 178

      #3
      Got it -thanks. Is it gonna get hot?
      AquaCraft UL-1 59mph.
      Motley Crew 61mph.
      JAE 21FE ~~~ 70 MPH Club ~~~

      Comment

      • ильмат
        Junior Member
        • Feb 2013
        • 3

        #4
        Now tell me how things are with factory flex shaft? Can I run the boat without fear that it will come off?

        Comment

        • 704Authentic
          Senior Member
          • Nov 2012
          • 178

          #5
          Up grade stock shaft - OSE has them.
          AquaCraft UL-1 59mph.
          Motley Crew 61mph.
          JAE 21FE ~~~ 70 MPH Club ~~~

          Comment

          • Fluid
            Fast and Furious
            • Apr 2007
            • 8012

            #6
            Originally posted by 704Authentic
            Got it -thanks. Is it gonna get hot?
            It will if you run too long, it depends on how you run and the attitude of the boat. Check temps often at first. Set the timing at 15 degrees.





            .
            ERROR 403 - This is not the page you are looking for

            Comment

            • ильмат
              Junior Member
              • Feb 2013
              • 3

              #7
              I would buy a shaft for Steven, but it does not send to Russia!

              Comment

              • 704Authentic
                Senior Member
                • Nov 2012
                • 178

                #8
                Guessing 4-5 mins. run times, gonna run full power as much as posssible and as dry as possible. :)
                15 degress? Motor is new, is that a good break in setting? or does it even matter...
                AquaCraft UL-1 59mph.
                Motley Crew 61mph.
                JAE 21FE ~~~ 70 MPH Club ~~~

                Comment

                • Heaving Earth
                  Banned
                  • Jun 2012
                  • 1877

                  #9
                  15 degrees is correct. Much of the heat generated is when the battery voltage starts to drop, so try to limit your runs between 3-4 minutes tops and check temps

                  Comment

                  • 704Authentic
                    Senior Member
                    • Nov 2012
                    • 178

                    #10
                    When connecting Bullets in a series, for first time, I got a little confused. (Sometimes it doesn't take a lot.)
                    Looking for the Best/Most Common procedure.

                    1) ESC positive, negative wires are what male,female connectors?
                    2) Battery 1 positive, negative wires are what male,female connectors?
                    3) Battery 2 positive, negative wires are what male,female connectors?
                    4) I guess at this point the jumper wire between batteries (neg. to pos.) is obvious.?

                    There must be a simple formula somewhere. But, Please don't make it look to easy:)
                    Thanks in advance - again.
                    AquaCraft UL-1 59mph.
                    Motley Crew 61mph.
                    JAE 21FE ~~~ 70 MPH Club ~~~

                    Comment

                    • Heaving Earth
                      Banned
                      • Jun 2012
                      • 1877

                      #11
                      Mine
                      Esc - black is female, red is male
                      Batteries - black is male, red is female
                      Connect esc black to black on pack 1
                      Red to red pack 2
                      Then connect the two packs together red to black

                      Comment

                      • 704Authentic
                        Senior Member
                        • Nov 2012
                        • 178

                        #12
                        Picked up a deal on a "lightly used" Leo 4074 - 2000kv.
                        With top speed & handling being the goals,
                        do I use it,
                        or would you stick with the Castle 1415 2400kv.

                        Thanks,
                        AquaCraft UL-1 59mph.
                        Motley Crew 61mph.
                        JAE 21FE ~~~ 70 MPH Club ~~~

                        Comment

                        Working...