Motor swap

[Mike whiting]

I am changing out motor and esc going with the swordfish 200a and a leopard motor. Can't decide between the 3674 2650kv or 4074 2000kv. Pretty much witch is faster of the two still learning about the motors. Will the 4074 motor fit in the mc. Want to run up to 6s and want it to be able to do some crazy speeds
Thanks

[Rumdog]

Neither are a good choice for 6s. The 4074 should fit, but you will want to add support for the rear of the motor.

[Mike whiting]

What is the highest cell you can run with those motors? what kind of speed can I get with that setup do you think ? Any suggestion on a affordable motor that I can run 6s I wanted to run 2 3s batts everyonce in a while but mainly 2 2s

[Rumdog]

Why not just keep the stock motor and upgrade the esc?

[Mike whiting]

I don't know What do you suggest and how fast do you think it would be what esc

[BLAZE WON]

i think that by changing the speed control to a 125,putting the 5.5 bullets on everything and using 5 cells, the boat should run all day in the mid to upper 50,s without breaking and replacing parts all the time and still have a very controlable boat.

[Mike whiting]

Do you run 1 5 cell or a 3 and 2 cell

[LarrysDrifter]

I'd be careful with "crazy" speed in that hull. Doesn't look like there is too much room for center of gravity adjustment. She might blow over a bit too easy with speeds approaching and upwards of 60mph. Just my opinion, as I don't own a Motley Crew.

[BLAZE WON]

you would use 1 3 cell and 1 2 cell. i dont think that the mc or the mg are 60 mph boats. even though there are a lot of guys running 60s with a miss geico its just not made to do that for any length of time before they start coming apart. imo i think they can both run mid 50's but the motley is much easier to obtain those speeds without spending a lot of $$$$. again, i own both boats and the motley is the bang for the buck.

[bbosncali]

I am changing out motor and esc going with the swordfish 200a and a leopard motor. Can't decide between the 3674 2650kv or 4074 2000kv. Pretty much witch is faster of the two still learning about the motors. Will the 4074 motor fit in the mc. Want to run up to 6s and want it to be able to do some crazy speeds
Thanks

I ran my mg with a tacon 4074 2000kv on 6s with a x642 and hit 63.4

[LarrysDrifter]

2000 is a lot of kv for a single drive. It's even a hot setup for a twin.( which would be sweet by the way ).

[Mike whiting]

What esc? Did u run 2 3s and how long can you run with that setup?
I am liking all these ideas just trying to figure it out so thanks to everyone

[bbosncali]

Hey I didn't say it was a good setup at 6s lol I only got like 3min run times...but fell in love with the cc 1518 62mph and 6-7min run times very happy that motor rocks can't wait to see what it does in my genesis

[bbosncali]

I ran,a,seaking,180a it was fast but run times were crap went to a cc1518 1mph slower with only 1 outing and my shaft was slipping because I lost it that day an more than doubled the run time

[dana]

what about a leopard 3674, not too much motor but an upgrade from stock