I need a few ABC props

[eXoNerated]

Hi Does anyone have some raw ABC 1918's they would part with? I know I could call Jim but I want them like right now. I want to run my scale in oval trim this weekend and see how far my calculations are from reality.

Thanks,
Hubert

[T.S.Davis]

Do he even make a 1918? Seems like something he would but I haven't seen that.

[jim82]

He makes a 1918-10-50 is that the one you after?

[eXoNerated]

Hi Terry and Jim,
Is the "50" the BAR and "10" the rake? I have a motor I tuned that I think will be a good oval motor. The calculator seems to like the 1918. But I'm not positively sure of which port of that prop it likes. Maybe I should get all the available s and test each one.

In a performance hydro with 10s lipo @ 9800 mah and a castle 240. Prop wizard selected an ABC 1918 as the most efficient prop for the setup.
Resultant:

28,221 rpm
141 amps
4,955.78 watts Pin
4,728.58 watts Pout
run time 4.15 minutes
est speed 79.20 mph or 127.46 Km/h
Eff. 95.42%


The efficiency doesn't begin to drop off till 284 amperes surely the beginning of the end @ 10.5 kW. Here are the motors constants and parameters

Rm .oo5 ohms
Kv 824
Io 3.27 amps @22.5 volts including radial fan load.
Weight 448.8 grams
12 slot 10 poles

What a long day....

[dasboata]

Hi Does anyone have some raw ABC 1918's they would part with? I know I could call Jim but I want them like right now. I want to run my scale in oval trim this weekend and see how far my calculations are from reality.

Thanks,
Hubert

I have a new one in stock I only sell finished props PM me if interested thanks

[eXoNerated]

Hello Chris,
Is that right for your name? Do you offer the aging service for the ABC beCu ? A few of the props i want done with a special LE backside detail . Those ill; likely do myself but I would possibly interested in a hardening service. Do you do stainless as well?

Thanks ,
Hubert

[dasboata]

Hello Chris,
Is that right for your name? Do you offer the aging service for the ABC beCu ? A few of the props i want done with a special LE backside detail . Those ill; likely do myself but I would possibly interested in a hardening service. Do you do stainless as well?

Thanks ,
Hubert

Ya guys with charts and grafts scare me I'm going to pass,, but LMK if you want that 1918

[eXoNerated]

No thank you I dont want a prepared prop at this time. Andy Brown or myself does that. Im looking for raw 1918's

Regards
Hubert

[jim82]

Post over on intlwaters.com Mark or Walt may have them

[eXoNerated]

What is the direct line to ABC and Jim S. ? I cannot find it in my contacts.


Thanks
Hubert

[dasboata]

What is the direct line to ABC and Jim S. ? I cannot find it in my contacts.


Thanks
Hubert

Ill sell you the raw 1918 10/50 $30 shipped