Tweet
I haven't seen Teflon coated props before. I'm used to polishing my cnc pops. Is there a advantage to Teflon over polishing? Or is the props made of something else? They gray in color.
-
Last edited by twissted; 03-15-2014, 04:54 PM.twissted from speed. Lead, fallow or get out of the way. Copy cats in back of the buss!!! -
I should point out that they are thinner and lighter in weight than I'm used to. The props you see here are X945 cnc props from kintec. I'm thinking that they may be the magnesium hybrid props which I'm not familiar with.013.JPGtwissted from speed. Lead, fallow or get out of the way. Copy cats in back of the buss!!! -
Have you done anything to them or are the stock . If there CNC i'd still remove the tongues for low amp draw .Comment
-
The props from Kintecracing came sharp and de-tongued the props I go from offshoreelectrics I had to de-tongue. I don't mind doing it. It is nice to see performance props come that way though.twissted from speed. Lead, fallow or get out of the way. Copy cats in back of the buss!!!Comment
-
twissted from speed. Lead, fallow or get out of the way. Copy cats in back of the buss!!!Comment
Comment