Bullet connectors for high current

[Anbjorn]

I have decided to run 2 packs of HYPERION G3 VX 22.2V 6S 5500 MAH 35C/65C in series and 2 in paralell. Motor Lehner 3080/7
What kind of connectors on the battery side will be safe to use in this setup?
What is the continous amp draw and peak draw I should aim for? How much can these packs handle? Or should the IR tempgun be my tool here?
Thanks
Anbjørn

[Jeff Wohlt]

Minimum 5.5.

[AntronX]

I went from 5.5 to 8mm connectors and love it. 8mm fit into each other better and seem to have tighter manufacturing tolerances. I had some 5.5 bullets that were so tight, they did not fully slide in. And some were too loose. 8mm plugs can fit two 10 gauge wires or one 8 gauge.