Tweet
I see the Etti 150 amp speed controller can handle a 300 amp burst. Will this be good for a hydra 240 24 volt replacement? I do just what the Etti says it can do with very short SAW runs on 6s and a 1521 1.5d motor and i would like to run 28 volts through it . What do you guys think
-
Last edited by Gary; 04-12-2009, 09:06 AM.PT-45, 109mph, finally gave up after last bad crash
H&M 1/8 Miss Bud 73 mph
Chris Craft 16 mph -
any opinions on this before i buy one.thanksPT-45, 109mph, finally gave up after last bad crash
H&M 1/8 Miss Bud 73 mph
Chris Craft 16 mph -
Gary, I have heard people beat it as hard as the Hydra and it was fine, it's a matter of fact, the Hydra actually burned... I don't own one, but I would by it in a second if I had to.:::::::::::::::. It's NEVER fast enough! .:::::::::::::::Comment
-
I have never heard of a bad review and meets its specifications. In most cases highly recommended.
DouggieComment
Comment