Cool Tool

[wshelley]

Phillips Cool Tool available!

Hi guys. The Phillips version is available! I couldn't find a decent tip that worked for a reasonable price so I had to modify #1 Phillips insert bits. It was more work than hope for but the end result looks to be good. Due to the extra work I'm asking $25 plus shipping for the tool. Shoot me a PM or e-mail to get one ordered.

Thanks for your patience!

Ward

[D. Newland]

Works great.

One recommendation. On mine, the handle set screw was a bit loose and stripped/unraveled the flex cable windings. I cleaned it up and coated that last 1 inch of the flex cable with solder.

[Punisher 67]

That is real innovative !
I bought myself one of these http://www.amazon.com/Dremel-575-Rig.../dp/B00005AXI0 for my Dremel a while ago to drill motor-mount holes in stringers and it works great as well. It should work well for motor-screws too if you modify the bit a bit.

Dremel also sells a 4 pack of shorty drill bits from 1/8 to 1/4 and less the 2' inches long . that with the 90 degree drive works like a dam for motor mounting in the stringers

[egneg]

I do not use it to do the tighten/loosen part as I like the feel of a allen wrench at this stage. I use it for the the screwing /unscrewing which is the tedious part.