Soldering T plugs?

[ray schrauwen]

One could bend the copper in the middle if it would make the setup easier to do plug ins.

I have some 1/8" thick copper plate I was thinking of using in a similar way. I could cut some pieces in a "Y" shape or a "U" shape.

[TRUCKPULL]

Ray

These are solid slugs(no bending). They are going in front of the ESC, with the batteries on each side,

So now I have + and - pointing right at the batteries.

Larry

[TRUCKPULL]

I just put the wire in the hole, it is not soldered yet, because I have to shorten the ESC wires yet.
For wrapping it, I am going to pick up some 3M electrical tape in Black and Red.

Larry

[T.S.Davis]

I use this to wrap anything that gets hot. Wont fail like shrink does. Stays put to 500 degrees.

https://www.uline.com/BL_6422/Silicone-Self-Fusing-Tape?keywords=silicone+tape

[TRUCKPULL]

I tried this a few different ways, this is what I came up with.

Larry