Leopard 4082 1800kv/raider 150a on 6s?

[Woohoo\o/]

First I wanna thank ose for providing such an affordable combo for my traxxas m41 all soldered and a jacket included. I got the last one too. Big thanks ose.

Okay so I would have gotten the 1600kv for cooler temps but I'm also okay with a drag style run.

My concern is the 150a esc since I see most people run a 180a. All my batteries are 6s. I dont and certainly cant afford to buy a set of 4s batteries right now. Think I'll be okay with the stock prop being 42mm for a one run and cool off period? Also could anyone recommend a prop that will not cook my components? I wouldn't know what to tell my wife if they burn up. The description says requires 2x 3s lipos so I'm pretty sure itll be okay on that 150a.

FWIW my m41 has a water pump that should help keep it cooler with continuous fresh water. Any info goes a long way. Thanks

Chris

[koen]

if you use TFL props take the 4419 (the 1.9 pitch is actually 1.2pitch) so every thing stays cool but not go bigger then46mm ,these are 3/16 prop shaft and always check temps and start first run no longer then 1min max and check motor ,esc and batteries temp

[Woohoo\o/]

Okay that sounds like a good start thank you kindly Koen. I will pick up that prop.

Chris

[Woohoo\o/]

if you use TFL props take the 4419 (the 1.9 pitch is actually 1.2pitch) so every thing stays cool but not go bigger then46mm ,these are 3/16 prop shaft and always check temps and start first run no longer then 1min max and check motor ,esc and batteries temp

Thanks for you the response but I tried to search for that prop (tfl 4419) but I cannot seem to find it anywhere. Can you or anyone point me out?

[tbonemcniel]

I think he meant 4519, as I don't think they make a 4419.

Here it is on OSE's store, but sold out. https://www.offshoreelectrics.com/pr...od=cnc-4519250

I've got a ton of CNC props I don't use, and I've been planning on selling. I know I've got a 4519. $15 for the prop + $10 shipping.

[Woohoo\o/]

Awesome thank youuu. Think I'll be okay with a 4519? I will pm you soon. Again thanks very much.

Chris

[Froggy]

I think he meant 4519, as I don't think they make a 4419.

Here it is on OSE's store, but sold out. https://www.offshoreelectrics.com/pr...od=cnc-4519250

I've got a ton of CNC props I don't use, and I've been planning on selling. I know I've got a 4519. $15 for the prop + $10 shipping.

I would be interested in your props if you have anything that would work on a 30 in cat with a Leopard 4082 1800KV

[koen]

i use prather 225 ,230 and abc 1715-17,1815-17 (cnc 4519 and 4714 d series) these will work , but every hull reacts diverend and always if you use a new prop check temps