aeromarine 36 sprint cat twin drive suggestions

[jaike5]

how did that race run with a five boat minimum ???
J.

[TRUCKPULL]

how did that race run with a five boat minimum ???
J.

By the third heat, two boats had dropped out.

Larry

[hiboatah]

tnx Larry
I don't like choices
Especially when the favorable choice entails a whole lot of work
The enticing thing is...the results are logically favorable
Amen Jay...life could be a whole lot easier but considering this is an extremely cool hobby, getting up in the morning each day looking forward to building a single would not be as purposeful as building a twin. no offense pls.
I'm going get building - tnx guys
btw rocketman and his cronies (Hansen Dam) inspires me to build this

[jaike5]

No offence taken ! Cool hobby is right on! I would rather build two boats than put double $ in one ! Raced with one in FLA. could only keep up couldn't pass him, cool boat though, and quick.
Cheers, Jay.

[T.S.Davis]

Larry's cat is disturbingly fast. Absoutelyly violently fast. I'll vouch for it. Might be the fastest heat cat I've ever seen.

Haha....If Larry had a youngsters eye balls it would be really tough to beat.

[TRUCKPULL]

Larry's cat is disturbingly fast. Absoutelyly violently fast. I'll vouch for it. Might be the fastest heat cat I've ever seen.

Haha....If Larry had a youngsters eye balls it would be really tough to beat.

Thanks for the KODOO's Terry.

Larry

[dasboata]

I am building the 36? Avenger same bottom as the sprint but more room inside going to run 4060 on 6 with some water cooled Xlx



Sent from my iPhone using Tapatalk

[dasboata]

Sent from my iPhone using Tapatalk

[TRUCKPULL]

Chris

That is the same hull that I run.
Info on my setup in post #2.

Larry

[dasboata]

Chris

That is the same hull that I run.
Info on my setup in post #2.

Larry

Larry sound like a good runner cant wait to finish it Troy cut it down a bit and built it super strong for me

[hiboatah]

Larry, no need to be humble about all those performance remarks. In picture 3, looks like she's haulin the stuff real good!

Terry, interesting how life serves us...when we are intelligent enough to use the resources, we are handicapped to do so...

Thank you for posting Chris. Looks like you're on your way. Interesting...locate the stinger location...fabricate your flex housing and motor mount angle simultaneously to create the flex housing route (usually w/slight bend)

I'll be getting the contour gauge indicator (that Ray recommended) to create a reverse contour of my sponson. I'm thinking this will be the easiest way to assemble a starting cardboard template for my motor mount.

Pray for me boaters, this is what I'm working with. Will be using 36mm motors as that's all that will be fitting between the deck and tunnel.IMG_1189.jpgIMG_1185.jpgIMG_1187.jpg

[dasboata]

aeromarine 36 sprint cat twin drive suggestions

delete