Help with Sonicwake proboat part.. Canopy screws

[mnm99]

Hi guys. Iv'e been loving my Sonicwake. I have been taking care of it real good since I use it in salt water, well except for 1 stupid thing I forgot. When I finish I always pull the shaft, rinse, clean and grease. All the other stuff to keep corrosion away from all the parts inside. It all looks great. Well my canopy cover screws are the one thing I forgot! 2 of them broke off from being exposed too long and not lubed up. Where can I find the grommets and finger screws that comes with it? I see they sell a new canopy with the screws, but no grommets. Thanks for your help.

[fweasel]

Are they the same as the screws they use on the other canopies, like the Zelos 36?

https://www.horizonhobby.com/canopy-thumb-screws-%284%29%3A-zelos-36-twin-p-prb286030

[mnm99]

Are they the same as the screws they use on the other canopies, like the Zelos 36?

https://www.horizonhobby.com/canopy-...in-p-prb286030

I'm not sure. The nut looks like a grommet in the boat itself, not a nut.

[mnm99]

Are they the same as the screws they use on the other canopies, like the Zelos 36?

https://www.horizonhobby.com/canopy-...in-p-prb286030

I'm not sure. The nut looks like a grommet in the boat itself, not a nut.

[mnm99]

I got it apart. The grommet is all messed up that the finger nut screws into. it looks like I need a whole nut setup too. Is there a contact to Proboat themself?