How to set drives at zero degrees

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • banixj
    Senior Member
    • May 2012
    • 107

    #1

    How to set drives at zero degrees

    Hello guys, acn you tell me if the procedure in the attached sheet is right or not?
    Thank you so much!
    prop drive setup.jpg
    HPR 115 kevlar bulletproof @90mph, MHZ Rapid carbonfiber, Bingo Race Minieco
    Futaba AIR TX/RX system with telemetry
  • E36racer
    Junior Member
    • Oct 2018
    • 11

    #2
    If I remember geometry correctly, that looks about right to me (not trying to be a smart @$$). But it has to be parallel with the flat surface below it to be 0 degrees. It does not matter what those 2 measurements are, just as long as they are the same it will be parallel.


    Sent from my iPhone using Tapatalk

    Comment

    Working...