Tweet
Just ordered this kit. The reason is that I want to make use of my 2x TP 5850/1000 kv. The hull is short, (46"/115 cm). So it fits nicely into the car. And its wide,(17"/42,5 cm). so I imagine 25 pounds rtr would not be a problem ? (6-10s/10-15000 mAh each motor). On youtube there is not a lot to find. So if anyone has any experience with this hull I would be thankfull.
-
-
do you need twin motors in this type of hull ? if your going to do the Crackerbox i would fit only a single motor , these hulls are really not designed for twins and also not for great speeds, keep it a good fun boat plus also keep all build / hardware specs legal incase you ever decide to race it or sell it to a modeler. -
Thanks. yes it probably turns badly without some massive turnfins. What about its straight line / speed abilities ? What problems will I most likely face at "good speeds". lets say 70 mph ?Comment
-
problems with the crackerbox at full straight speed is abit like an outboard tunnel hull at full speed . flip. your better off buying the zippkits mono hull as this hull will handle both turns and speed.Comment
-
The zippkits Vbox is a v bottom, The Abox is the flat bottom. I would not think 70 is impossible with the Vbox.I have power tool's, it will fitComment
-
No by rights a v hull mono is capable of a higher top end speed as opposed to a flat bottom mono hull.Comment
-
Yes its the vbox.
Here are two Abox.
Flex under the hull and a turnfin in the middle of the boat (1:37 min.)...50 mph and airborn..
Comment
Comment