FeCalc - Feigao motors

[calcagno45]

Ok, I got that message when I was running a 2p setup but not a 1p...

[ReddyWatts]

For those new to FE: Keep your WATTS under the motor rating, it is "very" important to not overload your motor and keep your AMPS under 75 percent of your controller and lipo ratings.

[ReddyWatts]

Added the 545 prop and the CC 180 HV controller.

[ReddyWatts]

GrimRacer

Added the GrimRacer props to FeCalc.

[tth]

Reddy I have a favor to ask. I am unable to add info to my text in Fecalc. Would you please add the specs for the Lehner 1950/7. Thank You

T. Hatch

[ReddyWatts]

Do you have the specs for the 1950/7 motor?

[tth]

Not sure on the specifics. I was hoping you had some " magical resource ".

[ReddyWatts]

Did not find the 1950/7 anywhere. You might email Lehner and see if they will provide the "io" and "Rm" specs?

[tth]

I e-mailed them now all can do is wait.

[exotica]

...does anyone have info for the FE Calc in regards to higher capacity batteries??? my data only goes upto 4900mah

[tth]

You can get the battery specs and add them yourself.

[6S HYDRO]

no 580 7l on the list just 6l to 8l

[Fluid]

Paste in the following. Not exact but close enough.

Feigao 580-7L : 1900 : 4.5 : 0.0061 : Neo : 7 : 14 : 545g




.

[6S HYDRO]

i get error in motor data when i paste that in before the ***end

[Fluid]

You will have to remove all the colons, I put them in to make it easier to read because without them the formatting stunk.



.