Identifying turn fin bracket

[eric113]

There a 1/8 scale hydro I been eyeing. It has some the hardware with some the hardware missing.
It has turn fin bracket, I tried doing a search for the most the mfg’s I could think of.
I guessing this someone made this one?

[TRUCKPULL]

That is defiantly a nice looking bracket.
It looks to be machined, either by hand or CNC
I like how the reinforcing rib is built into the bracket.
Does it have two mounting screws to the rear of the sponson, or just the one that we can see?
Two or more would be best.
As long as it is big enough for a 1/8 scale fin, you should be good to go.

If not you could always change it out, and sell it here on OSE.

Larry

[eric113]

That one thing I like about that bracket is that reinforcing rib. I believe has another screw on the other side.
I will find a turn fin with right dimensions. I think leaning towards aluminum.