Hi...the warning states that during the adaptive frequency run the minimum frequency range that you set ((freq_max-freq_min)/60) was reached.
In a first step I would suggest that you check plot the results as a function of frequency and make sure that they make sense - e.g. S11(f) should not be greater than 1.
If you want to investigate further, you can try rerunning the simulation using a smaller minimum frequency increment and compare the results to see if they are the same.
prototype pcb
In a first step I would suggest that you check plot the results as a function of frequency and make sure that they make sense - e.g. S11(f) should not be greater than 1.
If you want to investigate further, you can try rerunning the simulation using a smaller minimum frequency increment and compare the results to see if they are the same.
prototype pcb
Comment