zelos 48

[urbs00007]

finally finished blueprinting hull bottom of my zelos 48. ready to rig. T.P. 5670 840kv. swordfish 300 lite, revo 420 graphene 10s4p 10,000 mah (4-5s packs) I need to re-inforce transom to mount rudder off to the right. stock mount is inline rudder which I never liked the idea of prop blast going into the rudder. Does anyone know what to use to add to this hull? Is it fiberglass resin, epoxy resin, or what? Also, could use a prop choice. In Prather as I have a bunch. thanks, guys.

[Fluid]

I don't know of any off-the-shelf offset rudders large enough for your hull. Not sure what you mean by "add to the hull" but quality epoxy will stick to a properly prepared surface. For props start with an S250 or S255.

To be more clear, the correct designation for your packs is 10S2P, not 10S4P. You effectively have two 10S packs (each two 5S packs in series) in parallel, not four 10S packs.


.

[urbs00007]

zelos 48

I don't know of any off-the-shelf offset rudders large enough for your hull. Not sure what you mean by "add to the hull" but quality epoxy will stick to a properly prepared surface. For props start with an S250 or S255.

To be more clear, the correct designation for your packs is 10S2P, not 10S4P. You effectively have two 10S packs (each two 5S packs in series) in parallel, not four 10S packs.


.

thanks for the "p" clarification. thought 4p meant 4 packs. bought the zelos rudder from horizon hobby. going to mount it off to the right on the transom and wanted to strengthen that area.