Tweet
Well after 10+ hours of sanding off my first attempt at basecoat I finally got to re-primer my MHZ Mystic 1380. Wet-sanding should only take an hour or two and then its time for a good bath and degrease before setting up for round 2 of basecoat. Fingers crossed this time it comes out right.59631592736__7C17E567-50C2-4CB1-B034-E8C5F55C16DF.JPG
-
-
Good luck to you. I hope round 2 goes betterVac-U-Tug Jr (13mph)Comment
-
Much appreciated!Comment
-
-
-
i acquired another boat yesterday...LOL coworker gave me an FT012 that he found on a pond he fishes... hes not an rc guy, and they didnt have a controller... its an early version with an integrated receiver/esc unit, so that got torn out yesterday...LOL i am assuming the battery is shot, since its been plugged into the esc for 2-3 years....but we shall see if it takes a charge, in a safe place away from any combustibles of course.... i can throw the stock esc from my vector 70 in it and a spare reciever for the time being..LOL nothing beats a free boat... even if its just a cheap plastic boat....LOL
**edit** the battery is toast... not even going to try charging it... voltmeter on the leads shows. 0.04v, and its a 3s.... not going to risk it... 3s 1500mah packs can be had cheap enough.... a fun little winter projects now, since i wat to tear it apart and paint it custom, since the stock red graphics scheme is pretty cheesy to say the least.... it may end up in the Stihl Livery, or something along those lines... LOL i am a Bronze Certified Stihl technician...LOL
stihl livery.jpg
1436488838074-P-2820655.jpgLast edited by bogieboy; 11-27-2019, 10:44 AM.Comment
Comment