Proper "X" Demension (drive height) for TFL P1 Outdrive

[Checkmateguy01]

I can't find any references for exactly how high (or low) to mount the P1 drive on the v-bottom i'm working on. Just going by some full scale references, i have it measured out so that the point of the lower unit bullet will be about 1/8" below the bottom of the boat. Before i drill and cut the opening in the transom i want to get a few opinions on the correct "X" dimension and where others have mounted them, or if anybody has a TFL Patron Saint with the P1 drive how high is the drive mounted on one from the factory?? Thanks

IMG_2373.jpg

[dasboata]

I use adjustable struts on all my boats . I would make the X dimension adjustable up to 1/2" down to 3/16-1/4" good luck !