When blue printing your hull.........

[Spot Me 2]

What is your favorite filler to use when you blueprint your hull and why???

[ApacheDude]

Quick question: What is blueprinting your hull?

[Avanti]

I used automotive glazing putty simple because it was what I had

blueprinting: is making your hull bottom straight with sharp edges

[old guy]

On my nitro boats I used to use epoxy resin and micro balloons. make sure your sanding block is 16" or so for the inside edge. I used the Grait plain wings sanding blocks. I used 400 wet and dry and finished it with 600 W/D. I used 3M Scotch tape on the in side of the tunnel the resin will not eat it or stick to it so after it drys you just peal it off and start sanding. that was the way the manufacture showed me and it works.
Hope this helps the old guy

[raptor347]

I like Evercoat Polyflex glazing putty. Sands easy and remains flexible. Perfect for glass hulls.

[Spot Me 2]

Man, I posted this a month ago, and I just get some responces now??!!??
The boat already has a couple coats of paint on it.



Luckily I still have to do the bottom.

[Avanti]

it's never too late to go back and blueprint
sorry for the delay

[raptor347]

The bottom of all my boats are ugly. Very strait and sharp, but ugly.