Hydro and Marine setup

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Red Rooster
    Junior Member
    • Dec 2015
    • 3

    #1

    Hydro and Marine setup

    Hello, I am new to the forum, and fairly ignorant to boats. I recently aquired a hydro. I have been searching and I think it is the viper model. It's 24" long, non turbine, no wing. I have a ton of short course truck stuff so I put a 3500kv 4 pole motor in it. Planning to run 2s and 3s. I know this is not an ideal setup, but it is free and I figured I would give it a go to see if I like the boating. My question is what would be a good prop recommendation to start with?

    I am trying to figure out how to post a pic.

    Thanks.
  • Fluid
    Fast and Furious
    • Apr 2007
    • 8011

    #2
    Check your HOTMBC Facebook message.


    .
    ERROR 403 - This is not the page you are looking for

    Comment

    • Red Rooster
      Junior Member
      • Dec 2015
      • 3

      #3
      You coming at me from both directions haha.

      Comment

      • Fluid
        Fast and Furious
        • Apr 2007
        • 8011

        #4
        Just trying to save some typing....


        .
        ERROR 403 - This is not the page you are looking for

        Comment

        • photohoward1
          Fast Electric Addict!
          • Mar 2009
          • 1610

          #5
          3s. Maybe 438?


          Sent from my iPhone using Tapatalk

          Comment

          • Red Rooster
            Junior Member
            • Dec 2015
            • 3

            #6
            ok been having a blast with a grimracer 38x55 but back to the drawing board.
            going to order motor, esc, and props. repaint hull and re rig.

            any suggestions for motor esc combo. really don't want to sink a fortune in this boat, maybe the next one. I was thinking the sss3674/2075 or sss3660 /2050 kv and the ose 150a. i don't know, that is why i am asking you guys.
            my goal is 50+ish mph on good water, would like to do it on 4s.

            1st video cog to far back....

            Last edited by Red Rooster; 01-08-2016, 09:08 AM.

            Comment

            Working...