Tweet
Hardware suggestions for NQD arrow jet rigger
Hiya guys 
I have a nice lil' 19" NQD arrow jet rigger hull that I've been sitting on for awhile now. I was going to put a Traxxas outdrive on it but I had to scrap that idea because it's too shallow
.
I am prepping the hull for orimer & oaint and I have decided to go with a conventional 2s - 3s 380 power system.
The rear transom is 2.5" x 1" & the inside of the tub is 12" x 2.25". I will probably power it with my 2s 35c 6000mah Rev-Tech bullet packs.
It maybe a while before I start the build but i am looking for suggestions on a motor mount, servo, rudder, strut & prop.
Thanks
I have a nice lil' 19" NQD arrow jet rigger hull that I've been sitting on for awhile now. I was going to put a Traxxas outdrive on it but I had to scrap that idea because it's too shallow
. I am prepping the hull for orimer & oaint and I have decided to go with a conventional 2s - 3s 380 power system.
The rear transom is 2.5" x 1" & the inside of the tub is 12" x 2.25". I will probably power it with my 2s 35c 6000mah Rev-Tech bullet packs.
It maybe a while before I start the build but i am looking for suggestions on a motor mount, servo, rudder, strut & prop.
Thanks
Comment