How to Wire Eagle Tree

[knpc]

I got my eagle tree V3 from OSE today but I'm not sure exactly how to wire it. I know it get wired between the batt and esc, but how? Its going between a castle 240 and 4s2p lipo packs with 5.5 bullet connectors. Any explanation or pictures would be very helpful.
Thanks
Kevin

[Steven Vaccaro]

right before the esc. So if you have male bullets on the esc, you will need females on one end of the eagle tree and males on the other side that go into the packs that are wired.

[knpc]

Thanks its all wired now. It seemed too easy to be right. I'll take it out in the next day or two and post the data.

[AntronX]

right before the esc. So if you have male bullets on the esc, you will need females on one end of the eagle tree and males on the other side that go into the packs that are wired.

I would recommend using male plug on positive (+) battery wire, and female on negative (-) battery wire. On the ESC, plugs would obviously have to be reversed - female on (+) and male on (-). This way it's impossible to connect battery to ESC at reverse polarity.

In my opinion, stupidproofing this part is a good idea.