Need a new ESC for SV27 powered Pickle

[flyboy320]

I had a CC Barracuda 80amp ESC running in my Vac-U-Pickle with a SV27 motor. It was running great (a bit hot at time, around 110f after 6min), but yesterday after running for about 15sec., pop noise and some smoke. So I need another ESC.

The boat is just for sport running. I liked the CC as I already have the programmer that I use on my CC35 ESC thats on my Trex heli. But also read about the ETTI and the ones from Hobbycity.

http://stores.ebay.ca/ETTI-RC-SHOP_Brushless-Speed-Controller_W0QQcolZ4QQdirZ1QQfsubZ2QQftidZ2QQtZkm

http://www.hobbycity.com/hobbycity/store/uh_viewItem.asp?idProduct=3728

Anyone have any other recommendations (or does anyone have one they want to off-load!!). I don't want to spend an arm and a leg on this as like I said, its just for hacking around with.

Cheers...

[JimClark]

Just get the SV27 ESc

[Heath M]

Send the Barra 80 back to castle and they should upgrade it to the Hydra 120 for a small fee...

Heath

[flyboy320]

I have a water cooling plate on it, and its been well used, and no receipt, think its still worth a shot?

[Heath M]

Everything is worth a shot,
I damaged mine and when i inquired about repairing it they said they would upgrade to the 120 for a fee.. $80 i think it was..

Heath

[Heath M]

email them about it

[flyboy320]

Don't ask, don't get :)

I'll email them and see what they say.

Thanks bud...

[flyboy320]

Well got a very fast response from CC

Yep, send it in. :) Upgrade to the Hydra 120 for $105.

Great customer service...

[Heath M]

Same email i got,still it to send it though,have to wait till the allmighty green back drops again :)

Heath