Titan 40 Build - Trim Tabs?

[Bullwink]

I just completed my Titan 40 Build for PMono racing. It has a 1521 1.5D and weighs 9 1/4 lbs. on 4S2P. The middle of the wet well is 1/2 inch from the bottom of the hull, the bottom of the well is 1/4 inch from the bottom. My question is do most folks racing these hulls in PMono use trim tabs and if so, how big and how close to the stinger? I have tested the boat a couple of times. It runs perfect with no chine walk now but I know rough race water is a lot different. Jay, (Fluid) I would appreciate your input.
Titan 40 001.jpgTitan 40 002.jpgTitan 40 004.jpgTitan 40 005.jpg

[Fluid]

I put trim tabs on my Titan 40 before I ran it but they are set parallel to the bottom. I doubt I needed them.


.

[Bullwink]

Thanks Jay. I thought maybe if the boat was trimmed correctly it might not need them. I will give it a try and can always add them later.