DHP marine esc 70a - how to calibrate throttle range

[jotto]

I have just purchased a Dragon Shark Mono-1. This has a DHP marine esc 70a. I am using a Futaba 3PM transmitter with it.

Does anyone know how to calibrate the throttle range on this ESC? According to the instructions (http://www.jperkinsdistribution.co.u...structions.pdf), the ESC has "auto throttle range" by default, but how does the ESC know what my max is?

2014-07-28 00.45.36.jpg

[Alexgar]

looks like the same instuctions as a suppo esc matbe these will help?
http://www.hobbyking.com/hobbyking/s...2X53414X59.pdf

[jotto]

looks like the same instuctions as a suppo esc matbe these will help?
http://www.hobbyking.com/hobbyking/s...2X53414X59.pdf

Thanks... yes, seems like it's the same. Some of the Suppo escs have a "manual" throttle mode where the throttle range is set when entering and exiting the programming mode. Mine doesn't have that, though.

The FAQ describes a manual calibration here: http://www.suppomodel.com/faq.html . I don't know whether it applies to my ESC, though.

[ray schrauwen]

No calibration needed that I know of for Suppo's. This is a Suppo design esc.

[jotto]

No calibration needed that I know of for Suppo's. This is a Suppo design esc.

But still, how does it know what the limits are? It's supposed to "remember" the min and max throttles seen from the receiver, but what if I change the radio system (which I have now)?