Hello everybody
,
I picked up this new Villain recently & after looking in my boat parts drawer I realized I have almost enough stuff here to do a complete single stinger drive setup. I know it may seem like a sin since villains aernt illains without the twin steerable outdrives, but I might get a wild hair and try it anyway
I have a Cordite SS1 motor w/ Collette, Astroflight 207D ESC, 3/16" adjustable stinger drive, rudder & an x447 prop and stuffing tube...
what I'm wondering is how I would set up a stinger drive and make it work is a single ?. also the deep V section in the back of the boat is only 4 inches long, I really don't think I can cram a motor mount a stuffing tube brace and the motor into a 4 inch long space ?. also what's the easiest way to sew up the end of the stuffing tube closest to the motor so it doesn't leak water w/o hindering the flex shaft ?.
any thoughts or suggestions would be appreciated, Thanks

I picked up this new Villain recently & after looking in my boat parts drawer I realized I have almost enough stuff here to do a complete single stinger drive setup. I know it may seem like a sin since villains aernt illains without the twin steerable outdrives, but I might get a wild hair and try it anyway
I have a Cordite SS1 motor w/ Collette, Astroflight 207D ESC, 3/16" adjustable stinger drive, rudder & an x447 prop and stuffing tube...
what I'm wondering is how I would set up a stinger drive and make it work is a single ?. also the deep V section in the back of the boat is only 4 inches long, I really don't think I can cram a motor mount a stuffing tube brace and the motor into a 4 inch long space ?. also what's the easiest way to sew up the end of the stuffing tube closest to the motor so it doesn't leak water w/o hindering the flex shaft ?.
any thoughts or suggestions would be appreciated, Thanks

Comment