I’m new to the RC boat world and looking for some help on my current setup. I have a HK Genesis with the stock 2075kv Water-cooled Brushless Inrunner, Turnigy Aquastar 120A Water-cooled ESC, and 2x 4000 mAh 30c 3S Turnigy lipos running in series for 6S power.
My first run with this set up yielded OK results and ultimately broke the stock (plastic) prop after only 5 minutes of test runs. I have been doing some research to try and order a new prop and came across a lot of information stating that I may be over powering the boat and causing more damage than good. Is this the case? Should I change anything or just look for the right prop that won’t put too much stress on the motor that is already being over powered?
Any help would be appreciated.
Please no trolling. Thanks
My first run with this set up yielded OK results and ultimately broke the stock (plastic) prop after only 5 minutes of test runs. I have been doing some research to try and order a new prop and came across a lot of information stating that I may be over powering the boat and causing more damage than good. Is this the case? Should I change anything or just look for the right prop that won’t put too much stress on the motor that is already being over powered?
Any help would be appreciated.
Please no trolling. Thanks
Comment