My free replacement boat suggestions?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • rotarypower101
    Junior Member
    • Feb 2009
    • 23

    #1

    My free replacement boat suggestions?

    So I have/had a nice Genesis that I put together based on what I have read here.

    It is a modest boat, ran reliable and great every time based on the suggestions followed here....

    Well until my “friend” decided he wanted to do close high speed passes next to the ladies sitting on my Seadoos to impress them....

    Long story short the hull on the Genesis is not more robust than a Seadoo hull, and is chipped up pretty bad all the way down the sponson as well as its split down the side on what I assume is the parting line seam...


    I was told he would replace the boat, and I am wondering if anyone might be able to set me in the right direction.

    What should I be looking at as a replacement?

    I take very good care of my items, and I feel I have my feet wet enough to upgrade to a nice quality unit.


    If I were to give a few desires, I would want reliability, quality of construction, run time over ultimate speed, and a aesthetically pretty finished product.

    The idea is to take the replacement cost and upgrade with a roughly similar model but higher quality.


    TIA
    Last edited by rotarypower101; 06-10-2014, 02:15 PM.
  • Fella1340
    Fast Electric Addict!
    • May 2013
    • 1035

    #2
    I think a HPR 06 is the best choice out there. Perfectly built and jaw dropping inside and out. Get the bulletproof layup and try another run at the Sea-do!! Much better match. Well cared for it will last a lifetime. Capable of 125 mph plus with an insane setup if your a heavy risk gambler! Check out the videos and the website. Nothing else comes close, except a bigger hpr! It's your only looking for one great boat and never want to replace another cheap flimsy hull it's worth every penny if you got the money. It needed to be mentioned seeing as though no budget was mentioned!

    Comment

    Working...