Cannot get ESC to work

[Joecisnero]

I recently purchased and installed the OSE Spartan Combo V2.
Leopard 4082 Motor 1600kv.
Leopard 180 Version 2 Esc with capacitor bank.
I am operting with a Traxxas Stock Radio and brand new receiver TQi 24 GHZ.
I have radio control of the steering servo but the ESC goes beep , beep , beep with a red flashing light at the same interval.I have tried everyting in the manual, PLEAASESE Help.

[Doby]

Three beeps to me indicates it is seeing a 3S LiPo pack...what voltage are you hooking up now? Could be the LVC is set for a higher voltage.

[kfxguy]

You may have a bad receiver connection. I've had that happen before... The three pin plug gets worn out ND a bad connection occurs

[Joecisnero]

Runnin on 6 cells 22.2

Three beeps to me indicates it is seeing a 3S LiPo pack...what voltage are you hooking up now? Could be the LVC is set for a higher voltage.

I am runin with two hyperion 45c 90
Two Batteries are wired in series to obtain 6cell 22.2 volts and when connected I get the tranmitter to turn and the esc just beeps a regular beat and blinks the red light with the beep

[Joecisnero]

its a new esc and I plugged tit in over 10 times , it fires up the receiver just fine and the Esc just beeps

[Doby]

Does your steering servo work? Just wondering if the BEC is pooched and you might need to run a separate receiver battery pack.

[kfxguy]

its a new esc and I plugged tit in over 10 times , it fires up the receiver just fine and the Esc just beeps

I understand that, but the power and signal are seperate. When mine would get a bad connection, the motor would beep, servo work but motor would not run. Tighten the pins in the plug a tad and it would run.

[nate]

Does this esc have throttle end points setup?

[Joecisnero]

thanks to everyone , it was the plug , the whole time , Thanks for lighting the path to the problem. I am up and running

[Joecisnero]

Thanks To Everyone

I understand that, but the power and signal are seperate. When mine would get a bad connection, the motor would beep, servo work but motor would not run. Tighten the pins in the plug a tad and it would run.

That was it , there was a poor coonection inside the plug. I was able to fix it and I am up and runnin good . She ready for the maiden voyage keep tuned and thanks again for lighting the path to the problem

[kfxguy]

Your welcome