tp-4030-800x600.jpgI'm waiting to get these from TP usa. I looked here first but they only had one. I'm going to put them in my modified Zonda cat.
I would like to know is any one is using thes motors in a cat and what props size your using? The Zonda is a 42 inch hull I use 6s and 1640/2 cnc props that are stock and I also have the 1445/2 cnc props. The hull has been beefed up to use larger props.
There is a build thread on here way forum member ManuelW did a HPRC5009 45" hull build using the TP4050 2350kv motors and was using a pair of Octura X447's and also some 50mm props cut down a bit on 6s with the same 180a turnigy/seakings like in your photo and they achieved speeds over 100mph.
Comment