GP335V2 20 SPORTS Hydro

[BAZCNG]

I am making an ML Boatworks GP335v2 20 sports Hydro
I am fitting an aqastar 3974-2200kv motor
And a water cooled Aquastar 120 ESC . Could anyone help with water cooling set up. It comes from the turn fin the goes to the water cooled motor then the esc and then out or is there a better way to so this,
Also would any one have the hardware set up details / motor position ect c of g flexy drive shaft positon As this is the first ML Boatworks boat I have built any help would be most appriciated

Cheers

Barryt

[JimClark]

Here is what I have done for a water pickup at the back of a sponson

[photohoward1]

That's going to slow it and it's going to pull on that side. Most if not all of us have it come through the rudder. Going to need a bigger turn fin too. Curved or bent in. Do some searching on the forum for some ideas and photos of peoples set-ups.

[JimClark]

Maybe on a Saw's boat but it has worked well on all my 1/10th scale hydro's I have built and raced.

That's going to slow it and it's going to pull on that side. Most if not all of us have it come through the rudder. Going to need a bigger turn fin too. Curved or bent in. Do some searching on the forum for some ideas and photos of peoples set-ups.

[BAZCNG]

Hi thanks for the reply. I am going to have my water pick up from the rudder. What i meant was were do i take it ti first the ESC or the motor?

[electric]

It is ESC first and then the motor.

[BAZCNG]

Many thanks